Adapters, Rails, Hardware & Gear
Accu-Shot monopod accessories adapt your rear support to your stock and your shooting: quick knobs, buttstock rail kits, sling studs, and the small parts that complete a rear-support setup. If you need to add a rear mounting point, fit a specific stock like the Sig Cross, or replace a part, the accessory you need is here. Everything is American-made and backed by a lifetime warranty.
Not every stock comes ready for a rear monopod, so these kits add the mounting point. Match the kit to your stock.
Some rifles need a part made for them. The BT78 Sig Cross buttstock rail kit is a good example: it fits the Cross stock so an Accu-Shot monopod mounts cleanly at the rear. If you run a specific chassis or stock and are not sure how to add rear support, check the product fitment notes or ask our team, and we will point you to the right kit.
Comparing rear rail kits? See every option side by side in the Accu-Shot monopod rail comparison.
Accessories also keep an existing monopod performing. Replacement feet, knobs, and hardware let you refresh a well-used monopod rather than replace it, and the lifetime warranty covers the monopod itself. Browse the full set and match the parts to your model and stock.
These are the questions shooters ask most about Accu-Shot Monopod Accessories. Below we cover what fits your rifle, where it is made, and what is in this collection. If yours is not here, our team is glad to help.
Use a buttstock rail kit to add a rear rail, or a sling stud to give the stock a stud a monopod can thread onto. The BT78 Sig Cross kit and BT14 Magpul PRS studs are examples; match the part to your stock.
The BT78 is a rail kit that fits the Sig Cross buttstock so an Accu-Shot monopod mounts cleanly at the rear. It adds the rear mounting point the Cross needs for rail-mount rear support.
The QK quick knob lets you raise or lower the monopod by hand to dial rear elevation onto target and hold it through the shot, with no tools. It is the fast way to fine-tune your hold behind the rifle.
Yes. Threaded sling studs such as the BT14 Magpul PRS studs give a stock the rear stud that a sling-stud monopod threads onto, so you can add rear support to a stock that lacks one.
Fitment depends on your monopod model and stock. Check the product page for compatibility, or reach out to our team in Kansas to confirm the right accessory for your setup.
Yes. B&T monopod accessories are machined in the USA and backed by a lifetime warranty on the monopods they support, the same as the rest of the Accu-Shot line.
Setting up rear support? Shop the rail kit, sling stud, or knob that fits your stock, or see the monopod mounting hub to choose your rear interface. Not sure what fits, reach out to our team in Kansas.
